FT Gremlin - Chad Lewis Frame - EMax Camera Mount

You have a EMax Baby Hawk and just bought the Flite Test Gremlin Chad Lewis carbon fiber frame (best there is!) to re-Frame your Baby Hawk guts but ..... the EMax Camera does not fit the included camera mount because it was designed for their power pack. Problem Solved! This camera mount will give you what you need to mount the stock Baby Hawk camera and provide all the protection the Chad Lewis frame provides. Except the camera harness which needs to be lengthened a bit, all the other parts just drop in without mod.

There is 2 versions, 1 with 3mm screw threads designed in and one with through holes. There is also some spacers since the Flite Test M3 Long screws are a bit too long and don't leave much thread room left for the screw that comes in from the other side.

If you print the threaded one then print at 0.1mm layer heights; else 0.2 should be fine.

Steal a small rubber band from your child for making those rubber band bracelets or order a pack on eBay or Amazon for next to nothing. They are used to hold the camera to the mount and go over the top and across the pegs that come out to the sides; I use 2, one over the lens and one over the circuit boards where the NTSC / PAL switch is. They come in handy for securing other things in your RC fleet so buying a bag of them would be good.

I can print you a couple mounts if you don't have a printer; find me on 3DHubs. (https://www.3dhubs.com/service/3DMyers)