January 17, 2018
Description
UPDATE: 2/3/2018 - I have added a full clip model to this because some types of PLA were breaking easily at the relief cuts in the first model. I have named this one PETG or TPEE just based on printing with a material that is more flexible than PLA which does not need the relief cuts. These can be printed in PLA as well but it might not stretch enough to bend with the tabs.
The peach in my cobbler needed a way to stop the knitting counter from going off in her bag when traveling with her supplies.
Few minutes in tinkercad...boom worked first try. Considering that never happens I decided to upload it in case anyone still had a similiar counter and needed to prevent it from functioning temporarily.
100% infill 0.20 mm layer, prints in under 10 minutes at 60 mm/s.
License:
Creative Commons - Attribution - Non-Commercial - Share Alike
Revamped_Outdoors
