Shameless Plug:
I spent quite a lot of time designing, prototyping, and perfecting this so if you find it useful I'd greatly appreciate a couple bucks using the Tip Designer functionality if you can spare it!
Version 2 Notes:
- Ready to print: For the prints that need supports (namely the top portions), I have included files that have supports built-in. Or if you prefer you can go with the versions without built-in supports.
- Redesigned handles: instead of my completely homemade grips these handles are based on traditional first-party controller designs
- Retaining lip: the new grip will allow you to securely slide the bottom of the 2DSXL into it, holding it in place so you won't have to worry about the unit falling out of the grips
- Securing latch: there is now a latch you can turn to prevent the unit from sliding out of the grips once you have it in place, might not be necessary but may offer better peace of mind.
Assembly note: In order to get the keying oval and cylinders to fit in their inlays you'll probably have to take a knife and cut off or sand off the excess "lip" (flashing/elephant foot) that appears around the bottom of the print that touches the print bed
Original Notes:
My first custom-designed practical print! Please let me know what you think and if you have any comments/suggestions for improvement. I struggled to come up with a design that would secure the 2DSXL to the grips but also allow it to close so I chose to keep the 2DSXL's folding ability. Honestly a couple pieces of scotch tape keep it in place very well if you play vertically like I tend to. Conversely once I'm done finishing/painting the model I'm going to see if I can lay down a layer of silicone for a non-slip coating that will hopefully keep the 2DS in place.
Tron08
