Tall Greenhouse

I made the following changes:

• Scaled everything down to 66% so it is slim enough to fit on my flower bench or windowsill
• Elongated the long sides
• Added height to the main body
• Added a baseplate
• Added support structures (inside and outside rims for the baseplate, inside corner pieces for the main body)
• Exchanged the support beams for the top roof (I kept the original angle, but I think it is just a bit too obtuse - see 2nd photo)

Please note that this will only turn out usable with a well calibrated and focussed laser. The structures are very delicate.

I cut this from 3mm HDF using an epilog zing at full power and 50% speed. Turned out quite stable. As always, quick-drying wood glue is your friend! As you can see in the 1st photo I used some coated wire to hold the pieces together until the glue was fully hardened.