Y Rod holder with clip

This is a Y rod holder for 3030 extrusions based on the Zaribo version. It has an additional push in clip which can prevent the rod from popping out of the holder and eliminates having to use a tie wrap so looks much neater.

You can attach/remove the clip without removing the holder (once the new holder is in place). Just slide the clip over the rod, clip the rod onto the holder then slide the clip back over the holder.

Print the holder with supports so the centre bottom nobble is printed correctly. I may make another version which removes the bottom nobble and adds a front lip instead for printing without supports.

After printing just make sure the clip fits tightly over the rod so it can not slide easily.