Lack Stack Kit - Table for Kids or Figurines

Inspired by Lack Printer Enclosure - LKM (shown in picture, right) I decided to make a table kit for my kids. A place for them to paint, read, do homework and such.

With the exterior honeycomb design and hidden locks, not only it increases the strength of the print it also look more attractive than ordinary plane designs. I think it will outlast the Ikea tables itself.

You can also use this to display your best prints and it can be a very nice companion for your Lack Enclosure!

===================
Note:

The parts should slide on with minimal friction and make sure you use some type of non oil based lubricant to avoid scratching the finish. I find that body lotion is a very good option, it does not soak into the material of the table and clean off easily too. Apply the lubricant on the parts, not the table legs. If the parts slide on too loose then wrap the table legs with 1-2 layers of tape at the location where the parts and table legs touches. Use the tapes as shims and try not to make the tape visible.

Use a drill bit or a tap-screw to create a hole first before fastening the screw to prevent your parts from splitting. I highly recommend that you use all the available screw holes to make this table rock-solid.

===================
Parts need:

2x IKEA Lack - Side Table (http://www.ikea.com/us/en/catalog/products/20011408/) $7.99 each
1x IKEA Lack - TV unit (http://www.ikea.com/us/en/catalog/products/90243297/) $14.99

4x LSK-Tall
6x LSK-Short
2x LSK-Center_Bottom
2x LSK-Center_Top
4x LSK-Lock (to fasten the top table)
optional Additional 6x LSK-Lock (in some case if you decide to fasten the whole thing to the floor)

===================
0.2mm Layer height
1.2mm Shell
10%-20% Infill
0% Support
No Raft

Lack Printer Encloser - LKM https://www.thingiverse.com/thing:1843235