Prusa i3 MK2 / MK2.5 Center Camera Arm

This is a camera arm designed to fit the Original Prusa i3 MK2 and MK2.5. It will NOT fit the MK3 and above.

This camera arm is designed to fit most of the PiCam cases on Thingiverse, such as this one: https://www.thingiverse.com/thing:1646474

This arm attaches to the underside of the heat bed, on the two front heatbed mounting points. It requires two slightly longer M2 screws to mount to the bed - simply unscrew the old ones, fit the arm underneath the bed, and screw the longer M2 screws through the holes on the arm and into the heatbed mounting holes.

A video demo of the mount in motion is below.

NOTE:
This arm will lengthen the Y-dimension footprint of the printer, meaning it may not fit inside existing enclosures such as the IKEA Lack table enclosure. If you need it to fit inside an enclosure, I would recommend fitting the Prusa i3 MK2.5/MK3 90-degree Heatbed Cable Bracket, here: https://www.thingiverse.com/thing:2837970.

---

My other designs are available here: https://www.thingiverse.com/JayLuvLL/designs

Facebook: https://www.facebook.com/jayluvll
Twitter: https://twitter.com/JayLuvLL
Instagram: https://www.instagram.com/jayluvll/
Imgur: https://jayluvll.imgur.com/