**JUNE 2018-UPDATE -if you are using a shorter than normal inner barrel consider using the new version of part GBP1, GBP1v2 has more support for shorter inner barrels.
(*Note:The outer barrel, front iron sight, metal reinforcing bar and bushing from inside the original rail system were disposed of/removed)
Front end with easy access battery compartment designed specifically for the G&G Raider Airsoft Gun.
Parts GBP2, GBP3 and GBP4 glue together to become one piece.(Lower front end)
Then part GBP0 is glued to it.
Parts GBP1v2, GBP5 and GBP6 glue together to become one piece.(Upper front end)
Then GBP11 is glued to it.
Optionals:
GBP7 (Front sight) requires an m4 nut and m4x10mm bolt/screw.
GBP10 (Rear sight) requires an m4 nut and m4x10mm bolt/screw.
GBP9(Eagle emblem) is glued on.
Optional large parts (These may save you time if you have a high build volume)
GBP12 (complete lower) Replaces GBP2, GBP3 and GBP4
GBP13 (Complete upper) Replaces GBP1v2, GBP5 and GBP6
Optional stock cap parts:(see picture of how to mod rear of aeg to accomodate this)
GBPEnd1 and GBPEnd2
or
GBPEnd1withoutQD
The QD used for this was from:
http://www.ant-supplies.uk/gun-sling-fittings/flush-fit-gun-sling-swivels.html
(picture attached)
Additional parts:
It is attached using the 2 screws that held on the original rail.
A additional nut(M4) and bolt(M4x25mm) are required to secure the slide on section
The nut is glued in place as per diagram
*GBP8 is not supposed to be included as it was ultimatley replaced and no longer required*
FRONT WIRING A GEARBOX
If you do want to use the battery compartment as more than a grip and your m4 is rearwired here is a good video: https://www.youtube.com/watch?v=LXIE-FVN8HI
I bought a front wired mosfet with wiring harness which made it much simpler.
xceptionzero
