Soldering Tin Station (for Multicore spools on request)

This thing was done by request and it is a variation of my older tin-station, that was made for smaller spools.

https://www.thingiverse.com/thing:695637

Now it will fit spools with a 20mm opening like this one -> https://imgur.com/a/0fu52ug

I did some other modifications to my old design, so f.ex. because of that this thing is larger there is room for a further tip-holder.

I've not printed this thing because I have no such spools, but checked everthing twice so it should work fine (fingers crossed) ...

Simplify 3D says it will cost you about 2 hours and 10,5 meters of filament with an infill of 15% and a layer height of 0.2 mm.

Hope you like it and please show us your Make :o)