Flowstand II for Tablets / Phablets

FTS-02A 'Flowstand II'

---

NOTE: Unfortunately Iinitially uploaded a slightly larger version of FTS- 02A_C. If you're one of those guys who downloaded the complete parts straight after this was released and found the end pivot piece didn't fit, download and re-print FTS-02A_C only - the new version should fit.

---

Hugely (functionally) improved version of FTS-01A - sharing the same profile, but with strengthened arms, fold-flat feature and sliding brace.

Version history:
Current upload = original

Build particulars:

1. Print TWO(2) of FTS-02A_A and ONE(1) of FTS-02A_B & FTS-02A_C. Suggested Makerbot 2 build placement in one of the above pictures.
2. Snap FTS-02A_C onto the end of both arms, noting the orientation of FTS-02A_C (the contour of the unit follows the contour of the ends of the arms).
3. Then snap FTS-02A_B into openings of both arms (best done in the middle of openings - you may want to use a flat-bladed screwdriver to pry the opening apart).

Total build time on Standard res on Makerbot 2 = ~1 hour. Commonly available 6mm dome stick-on feet will just about fit on the legs / rear pivot.