Cherry Pi II

Cherry Pi II is the new version of my original Cherry Pi Design with some improvements based on many hours printing on the original (http://www.thingiverse.com/thing:210028). I hope you like it.
Update: 18 April 2014 - I've added a couple of .stl files :-
An updated tower carriage that uses Open Build V Wheels
An effector with 3 x 25mm fan mounts
A modified bed clip to stop tilt when probing using FSRs
A modified stepper mount/base with access holes for the stepper fixing screws (they were a pain to get to before)
Also I've made a second set of delta rods at 250mm. I've lost 50mm of build height but the print quality has improved and I get a bigger bed area. The modified rods give a 200 x 200 x 200 build area (approx)
Andy
The major changes are :-
All electronics and PSU are now housed under the bed
Tower extrusions were reduced to 600mm to increase rigidity
Cross brace extrusions were reduced to 250mm
Delta rods were reduced to 200mm
Limit switches are now housed in the top printed apex pieces
Jhead mount re-designed to allow greater build height (270mm)
250mm diameter mirror used as print bed. 95mm print radius
Marlin firmware changed to Rich Cattell's fork
FSR Z probing installed
Printed T nuts used throughout (http://www.thingiverse.com/thing:28788)
Low friction spool mount
(http://www.thingiverse.com/thing:235925)