Summary

Goes on the 30mm fan to enable you to mount the BLTouch to my fan duct. This is meant to go over the rear 30mm fan and keeps the sensor out of the hot air stream from the heatsink.

I have not tried the mount yet, only a quick print to check dimensions, let me know if it needs any changes.

Print Settings

Printer Brand:

TEVO

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Delta (Little Monster)</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1618</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>35%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>make sure you add extended supports for the whole of the 30mm fan ring due to it being too thin for bridging. </p></div>

Tevo Little Monster - Volcano Fan Duct - BLTouch Mount

Tevo Little Monster - Volcano Fan Duct - BLTouch Mount

Related Models