iPhone 4/4s Wall Plate Cover (Single Switch)

iPhone 4/4s Switch Plate for utilization of an old iPhone to act as a control panel for home automation.

Will require some fancy power solution. this would include some kind to in-wall 120vac to 5v 1A dc adapter. Pin 23 is USB +5v, Pin 16 is USB gnd. There is about 10.5 mm between the phone connector port and the wall of the case. Please do your own pin out research and get super comfortable. i have no responsibility here.

http://thumbnail.egloos.net/600x0/http://pds18.egloos.com/pds/201010/06/27/e0036627_4cabf78b110e1.jpg

Features:
-supports and iPhone 4/4s
-positive clips that hold the phone in place
-holes for power, volume up, and volume down
-support for one decor switch
-holes for switch made small for proper drill out.
-0.5 mm face for phone to keep this as thin as possible.

Recommend sanding and painting the panel. may require some kind of 'fill' to fill in any grooves. Probably requires 2-3 thin coats of whatever color you like. Make sure to allow many days for curing. Paint after a good test fit and with holes properly drilled to fit. (I am not sure there is room to paint the back for additional opacity)

Print Face Down. 154mm x 129mm x 10.35mm. Glass or Kapton/Polyimide Tape provides a nice gloss.