Crawler Body Mount for Absima Ab2.4 At2.4 Mt2.4

The Absima Ab2.4 is a decent buggy, but ugle af.
So i designed a body mount to fit a cheap crawler body. You can recycle a reely rock crawler or similar vehicle, there are several brands selling the same rc car.

• No modifications on your Absima buggy/truggy needed!
• Just use the main part of the rock crawler body
• you can keep the interior, if you trim the bottom

Installation:

• The rear bottom part (Karohalter_hinten_bottom) is mounted to the stock damper bridge with 4 M3 Screws and Nuts.

• The top rear part (Karohalter_hinten_top) clamps the rear boom of the body with three M3 screws.

• You can now open and close the body like a door, no need to disassemble anything for service

• Mount the front lower part (Karohalter_vorn_V2) to the front differential, don't forget to insert the M3 Nuts into the bottom side.

• Mount the upper Part (Karohalter_vorn_V3_top) onto the lower Part.

• Use a drill to open the holes of the body above the new mount to 6mm diameter.

• You can now insert standard 6mm body posts and close the whole vehicle with two body clips. Easy to open and to close.

• I added a switch mount for the Hobbywing Ezrun 120A, which is located on top of the ESC fan and is accessible in front of the passanger seat.

Have fun printing and upgrading your Buggy.
It should work for the AT2.4 Truggy as well, i am not sure about the MT2.4 Monster Truck, since it has another damper setup.