longboard bash guard riser pads (boosted v1/v2 and others)

bash guards for your longboard's tail and nose. with boosted board support.

Riser pads designed to replace your stock risers pads that include a bashguard that sticks past the nose/tail. protects the board from the occasional smash. great for standing it on end.

There are three riser pads.

• generic riser that has no special cutouts which works on my boosted board v1. should work on any similar longboard.
• boosted_v2_rear It has slots where the cable clips hook in on the side.
• boosted_v2_front no such slots. (you could also just use the rear one. )

For the boosted v2 rear there are also two cable clips. which fit into slots on the rear riser pad holding the cables down in the same manor as the stock clips.

I printed these in PETG with 50% infill. 50% - 100% is recommended. PLA is not recommended. You assume all responsibility for printing and using your own riser pads.

I originally saw and used this thing https://www.thingiverse.com/thing:2441370 that seems to no longer exist. The cable clips for my boosted v2 broke all the time and I wanted to redesign them. Given the bash guard is no longer up I just designed them all from scratch.

I designed them in openscad, which i intend to upload later after some refactoring and maybe add some customizer stuff if I can figure that out.