Frame Support (Tevo Tornado & Creality CR-10)

I developed this frame support, which in addition to reinforcing the frame rigidity, DOES NOT LIMIT THE PRINT SIZE along the Z axis. You can print your models up as much the printer allows!

For this mod you will need:

• flat nut holders - 8 pcs.
• hemispherical nuts holders - 8 pcs.
• rod holder upper left - 1 pc.
• rod holder upper right - 1 pc.
• rod holder lower back right - 1 pc.
• rod holder lower back left - 1 pc.
• rod holder lower front (right&left) - 2 pcs.
• M8 rods 1 meter long - 4 pcs. (you need to cut the excess).
• screws M4x12mm - 12 pcs.
• M4 nuts - 12 pcs.
• M8 nuts - 16 pcs.

ATTENTION!
This set includes top right rod holder for two Z-axis motors mod.
Also, you can use only front or only rear frame support.

PS: It is not necessary to print the holders for nuts. Nuts M4 perfectly hold in the t-slot without holders.