Summary

I printed this Croc Pin with PLA Green and then White. I've been using a piece of 3/16 Polycarbonate mounted on glass and ruffed up with 220 sandpaper as my base and haven't looked back at Glue again. Anyone want to buy some semi-used glue sticks?

Nozzle:0.3
Speed: 45mm/Sec
I added some Gcode to Pause the print after layer 48 (0.2mm layer height) and move the nozzle up and out of the way so I could change the PLA filament to white.

; Setup to Pause the Print Job
G91; Set Coordinates to relative to last position
G1 Z30.0000 F200; Move nozzle up to change filament
G1 X-50.000 F6000
G90; Set Coordinates back to absolute to origin of machine
M0; Pause
; End of Pause

Print Settings

Printer Brand:

Prusa

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Prusa Clone</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>

Croc Spartan Pin

Croc Spartan Pin

Related Models