PanelDue holder and swivel box

Changelog:

• Added detents. The weight of the panel was too much to keep the panel in any position. It was enough initially, but then the surfaces wore in, and it started to sink.
  Detent added in Front panel and Display box

PanelDue case for the 5 inch version. It has a small box around it, that allows the display to be rotated. It is designed to be mounted in a coreXY with a heated chamber, facing the front. You can then make a cutout in the door it. The case has a finger tab to rotate it out.

First force the Front part into the Display box. At the top there are two hinge points and you will be able to push the Front into the Display box. It takes a little force.

The Paneldue is mounted inside the Front panel, 1 screw for the control board, 2 screws for the board initially, to hold it in. If you want to use the reset button, slide it in first!

The Control lid clicks into the Front panel with two cutouts. Then use two M3 screws to screw it down.

The Back lid then slots in and clicks into the Front housing, with again, two M3 screws that then clamp the PanelDue tightly as well.

In the Display case there are two little loops to guide the wires to the bottom.

I have not included screw holes in the Display case as that depends entirely on how you want to mount the whole thing.

I have included a reset button, slide it in from inside out and glue the top button on. I have not included an Erase button, but there is a tiny hole that guides a paperclip to the switch.

Just added a second box, this one is closed on all sides, except the front of course. :-)

Alaso added a few photos of the first quick prints of the parts.

The STL models are checked and optimised. The parts that need a different orientation to print properly are rotated to the preferred printing position.