360cam lens cover

Needed something to protect the double lenses on my 360 camera. This was designed to fit the vivitar 360 cam but there are loads of cameras that use the same body/design so it should fit any camera that looks like this.

It must be printed in a flexible material, it is not suitable for normal ABS, PLA, PETG etc etc.

simply print out, attach a rubber band and it's all good. Designed to remain fitted when attached to grip/selfie stick/tripod the cover just folds down out the way but it will fit upside down and at an angle if you wanted to fully remove it when attached to an accessory.

Printed in Generic "ebay" flex filament.
no supports necessary (may be needed if you struggle with the top of the domes)
fits on 150mm bed if angled 45deg
0.2mm layer height but should work at others
1Hr:20min print time

The cap should pretty much push fit on to the lens locking ring, if it doesn't you may need to adjust the scale.