Ear buds holder

Yet an other Ear_buds_holder. I found the existing ones not suitable for my use. I want a lot of protection and as small as possible. Therefor this cased design.

Because of the differences in ear buds there is a 32mm and a 37 mm wide design. Measure your buds back to back to estimate you need.

Put in your ear buds first. Right to the right and left to the left for the smallest width. Secure them with the 3.5 mm jack for all but Apple. Wind the remaining wire around and secure with the case.

Printing without support. Two almost the same halfs for the holder and one case. The difference in the two parts for the holder are the lips to easy open the combi of holder and case. The two parts make a sturdy fit when they come from my MK3. For other printers you maybe need some sand paper or glue. The case is not printed in vase-mode. The walls are 0.8 mm thick.

I had a design with one side for 3.5mm jack and the other for the new Apple plug. But the Apple plug is so small and short, that securing the ear buds with it and winding all wires together was a chalange. Maybe someone with a better idea for the Apple ones?

Hope you can use the design.