Parrot Anafi Battery Cover

I made this remix from https://www.thingiverse.com/thing:3100838
My appreciation for the good idea with the snap-on part :-)

My changes are as following:

• No fonts on it, so you can print it in a printfriendly position (openings upwards) and no supports needed
• upper side slightly rounded
• I did my own measurements of the connector part and modified the recesses for easier snap-on and best fit ( bigger tolerances )
• If needed scale it up / down a bit ( 0.5% ) because different printer tolerances. The width of the block is exactly 26mm
• Made of PLA

Edit 1.12.2018 , v2.1: the only difference the click-in part is a little bit harder. Doesn't matter in most cases because I have no feedback that the first version is too loose