DvZ'BRN Pin Takedown Caliburn Receiver

Prelude:
This thing is what kicked off Cpt Slugs development of his own takedown and interchangeable magwell.
It is a finished design and I spent a lot of time polishing it. If you enjoy what I did here and think I deserve your support, consider dropping by my Patreon: https://www.patreon.com/join/devilznerf?

What to Print:

• TopRail_Shortened is ALWAYS required (but should be identical to the newest generation of rail that comes with slugs version of the takedown magwell)

• IMPERIAL - Use with Official hardware kit or when retrofitting a genuine captain slug Caliburn

• METRIC - only when you can't get ahold of American hardware, allows you to use a 40mm plunger tube and smaller hex nuts for m5 threaded rod

• Print the corresponding Upper and Lower Receiver (Lower_Katana when you want to use Katana-like magazines only)

• Katana_Release is the required mag release for the Lower_Katana. The full-length version works with the original release

Optional:

• Plunger Retainer only works with the full length lower right now, it protects your plunger from popping out when transporting the split Caliburn

• Pusher Cap protects your Pusher O-ring from dust and garbage when transporting the split Caliburn

Support and Orientation:

• Upper: Print with the Front side flat on the printbed. Support not necessary and not recommended.

• Lower: Print with the angled bottom Magwell surface flat on the printbed. Support necessary, it is recommended to block support inside the threaded rod holes and inside the mag release slot. Alternatively use a high x/y distance from the model.