LED Light and push button switch for Flsun QQ Delta

LED holder and mount instructions... Mount will be held with screws already on the QQ.

2 small 3-4 mm holes for the cables to route through.

Wiring diagram shows the correct configuration for the switch to illuminate when LEDS are on.

Start with a small hole 1/8" to 1/4" for the switch and gradually drill larger with a step drill bit upto 3/4", this is pretty tough metal, use a good bit and take your time -
https://www.harborfreight.com/1-4-quarter-inch-3-4-quarter-inch-high-speed-steel-step-drill-44460.html.

Switch - https://www.ebay.com/itm/372416068160

LEDS, make sure you get WHITE, I had 4 LED circle 1.5" x 1.5" x .5" - but these 5 LEDs will do fine, if you can get them - https://www.amazon.com/ASC-Submersible-Fountain-light-Solar/dp/B013RJYTM0

Good luck and show your prints.