November 16, 2018
Description
Tronxy X5 Marlin 1.1.9 for MKS Gen L V1.0 board.
Upgrade your tronxy x5 using gen L v1. board by MKS.
A4988 and LV8729 Drivers used be sure to correct to the right ones !!!
EXP1 and EXP2 of MKS Gen L board should be rotated by 180 deg by soldering.
All standard wiring used except fan connector. Connectors polarity should be inverter for fan connector.
Extruder 2 connector used for second automatic fan used for material cooldown on extruder.
1.1 Fan connected to HE1 will autostart once extruder temp will go up from 50 to 270 C.
Dont forget to calibrate yours PID and change ones in the firmware.
SD Card support enabled. Used arduino SD Card module without sd card pin detection.
SD Card module connected to the AUX3 connector.
Use mount and PL-08N probe to add auto leveling if still not =)
https://www.thingiverse.com/thing:4249933/files
License:
Creative Commons - Attribution - Non-Commercial
wbanw
