Anet A8 X bracket for the X and Z axis.
Contains mounts for the motherboard and power supply.
Overkill design, but made to match the Anet frame
- works great and cleans up the electronics a bit
- might need spacers (1.5 mm) I think I screwed up my X width measurement?
- 5mm spacers are for power supply and motherboard
- Design is broken into 4 for smaller printers like the A8
- A light sanding and gorilla glue super glue hold the beams great in compression and tension.
- Tabs/T-beam point forward
- Full design is also included.
-They are easier to sand/glue together if you do not use a brim or any support, just a skirt to start your print works fine.
If you'd like any measurements, additional picture or anything, let me know and I'll see if i can help
Need:
P1
P2
P3
P4
5 mm spacer x 8
1.5 mm spacer x 2
SpaceCadet_77
