December 14, 2018
Description
A bigger version is coming
My own design of the ultra common front belt tensioner for Anet A8 ^^
2 Body parts for an ez print. The 2 body parts piece together
1 Pulley with bigger diameter edges to prevent belt attrition
(I don't like to have a pulley here but if peoples like that there is a pulley ^^)
2 upper stops to "prevent" hard scewing (not sure but... they are there ^^)
1 additional Push Bar, for frame reinforcing
1 Nut Plate with center wedges to prevent sliding when it's screwed
1 Screw with flat side under it to make the print easier
Inspired by
https://www.thingiverse.com/thing:2747511
Pushbar inspired by
https://www.thingiverse.com/thing:2306072
License:
Creative Commons - Attribution - Non-Commercial - Share Alike
-Ei9ht-
