ZD Racing Upper Chassis

After a crash with a scooter, this part from my rc car was ripped apart. Because I have a 3D printer I thought, why not design a replacement and print this out!?

So I sat down and used Solidworks to sketch this out. Worse still, this is my very first Solidworks sketch and I think it worked out pretty good!

Note: the screw holes don't fit very nicely, so I recommend drilling them out with a 2 mm drill bit.

I also drilled a hole into the centre of the part to support an antenna tube.

Printed with PLA which is not the strongest stuff on earth I know, and it probably should be printed in nylon which I don't have right now. Plus PLA holds up pretty good. Choice is on you.

Happy printing!