Raspberry Pi Zero WH Snap Fit Case (with camera port)

I wanted to try my hand at designing a case for a Raspberry Pi Zero WH from scratch. After a few iterations to get the snap together component to work without any structural failure, this is the result!

It fits the pi zero snug and is designed from one with male GPIO headers. A standard, female, ribbon connector should fit through the opening in the top, and there is venting for the CPU. The SD card opening does allow for removal and re-insertion of a micro SD card, but you may need tweezers if you have very short fingernails.

Have not been able to test fit the mini-hdmi port, yet, but it should be okay.