Golf club mount for GoPro or similar

I used this to get slowmo shots with my driver and to find out what I was doing wrong.
(This works OK mount wise, but the camera could film in better FPS.)

Mount is designed to form ~90 angle with the club and to stop camera going any further with out stressing the
bolt too much. Camera (gopro3 atleast) can be tilted back and fitted into the bag between shots.

You can use the normal gopro tightening bolt with this one... and maybe this will become handy ->
http://www.thingiverse.com/thing:252953 .

Can be used with every straight round object that has a D similar of that with a golf club (15mm +-2mm)

You'll need 4x 3mmx30 bolts + nuts and one 5mm nut for gopro. All nuts should lock into place.
I also used rubber ribbon between the mount and the club for extra grip and string for extra security
but never needed it. (can be seen in the pictures)

I tried to use very smooth corners etc. so that when putting this back in your bag between shots
it wouldn't get stuck to the bag fabric / rip it.

9.6.14 EDIT: File added with slighly elevated Z parts (fraction of mm).. Also please note: when using this do not press "Center / Place on platform" as it elevates the parts off the platform abt 0.5mm because around edges are not flush due to the bad stl translator. It did however print fine on my machine since gcode translator ignored rough non width edges... but to be sure, check before print with stl viewer of your choice.. sorry about this.