Go Board Game 1/4 Board

This is my design of the 19x19 Go Chinese Board Game.
It is 1/4 of the full board, as such 4 of the board pieces will have to be printed. - the edge of the inside counts as a line - i halved the triangle grove so that the two side together again form a single grove (hope this makes sense).

I added 1cm blocks and holes on the sides, so it can snap together, thus the board can be glued into a single unit or stored as 4 pieces.

The board, excluding the 1cm snap, is 15cm x 15 cm, with the grove then it is 16cm x 15cm.

As will be noted the stones fit the board, the are 14c\mm in diameter and 4mm in height.

I found my inspiration from the design by bqzero (https://www.thingiverse.com/thing:630914). However, his design (the 19x19) was way to small for my liking.

Printing:

-No supports will be required. (supports may be required, depending on your printing material, and settings, for the grooves at the bottom for snap grooves at the bottom)

-you will need to print 4 of the board pieces

-As per the rules I found (https://www.kiseido.com/ff.htm) Black starts out with 181 stones and White with 180. The total of 361 stones corresponds to the number of intersections on the standard 19x19 go board.

Please feel free to like it, share, it modify, print it, and suggestions and donations are always welcome.