Airsoft AK bullpup conversion kit

Requirements:
-Airsoft rifle - AK type Marui spec or similar

• Font rails (needed to mount new trigger assembly)
• basic tech capabilities
• micro switch FCU with electronic cut-off (Known types: Gate titan V3, Jefftron V3 processor)

Hardware needed:
2x M5x12
2x M5x30
1x M5x18
5x M5 nut
5x M3x12
2x M3x18
1x M3 nut
6x Brass insert (M3 inner, 5mm outer)
pen spring
small square button micro-switch
24AWG signal wire
1.5mm metal rod for trigger axle

Instructions:

1. install FCU
2. remove trigger and solder signal wires to the FCU microswitch
3. solder the other side of signal wires to new microswitch and glue it in place
4. • best to add micro connector for the new microswitch for easier disassemble
5. glue in the bolt and spring as shown in picture to trigger assembly.
6. assemble the trigger assemble (rod,spring etc)
7. install the old trigger cover
8. insert the 6 thread inserts like shown in picture to back plate
9. assemble as see fit.

NOTICE: its a DIY mod, any damage is modders responsibility only !
all parts can be printed without supports !
if you like it please donate