MPCNC CASE

A nice looking controller box for the RAMBo 1.4 and the RepRapDiscount Full Graphics Smart Controller.
This setup is for an MPCNC but can easily be used for other machines as well.

I recommend that you set the fan to blow from inside out and mount a filter inside in the front to prevent dust to enter the control board.
The fan needs to be 12V and connected to PIN 2 on the board. I haven't fully tested this myself yet but after adding the fan you need to change the code as one of the picture shows in the "configuration_adv.h" around line 184.

Timelaps of my MPCNC build
https://youtu.be/O3N5tAFIMpI

EDIT 2019 09 02
Original case for RAMBo 1.4 also fits RAMBo 1.3
A new case for MKS GEN L

EDIT 2019 12 07
New upgrade to Lid. Now with a reset button.
A new component, Reset button.
Fixed to best printing orientation for Lid

EDIT 2020 02 21
Information about FAN type and changes in code that needs to be done.

EDIT 2021 12 10
New Case for Mega 2560 + Ramps 1.4
An added new case from requests by a lot of you users.