Knight Pen Holder repaired and scaled (new hands!)

Imported, ran thru netfabb, scaled up 2540 for inches..then doubled that

-edit- someone in the original revised edition in the comments section said that cupped hands might be better...searched and searched and searched for the right hands...found them on another site
Imported into tinkercad, chopped off old hands, put in these hands resized to hopefully look like proportional hands, then my first ever attempt at meshmixer to smooth the lines between old hands and new hands (I did make wrists a bit thicker so they won't snap off easily)

End result is in the files...working on creating meshmixer support
Oh, had to reduce triangles because there were over 900K in original...reduced down to 100K w/o major loss of shape or design

This is my first attempt ever at a complete redo/revision of modelling a body type model...so be gentle :)

-edit- 2/26/2018 after editing hands...found that there were tons of errors...re-ran thru netfabb and replaced bad stl

-edit0 01/03/2020 created a support EZPrint using meshmixer to build already built in support stalks...