TBS Source One GPS, VTX, RX Mount

This is a Crossfire Immortal T, VTX and GPS mount for your V0.2 TBS Source One.
It also adds a middle tray for mounting your receiver above the VTX.
It was designed for RaceDayQuads Mach3 VTX and RaceDayQuads Glonass GPS (Without compass) units. I have since been told these are AKK VTX and BN-180 GPS rebranded units. The VTX's with the MMCX connector are the ones you want because you can use extensions with them easily.

UPDATE #1:---------------------------------------------------
I added a VERSION 2 with a small hole under the GPS case for helping to remove the GPS and I also tilted back the VTX antenna mount 25*.

UPDATE #2:------------------------------------------------------------------------
I added a beeper mount for a 12mm diameter piezo buzzer.
Will be a difficult print and require supports everywhere but it will be extremely functional when you nail it! Good luck!

Print with 15% support (or more!). You can switch filament colors during the print to achieve the look I have here. It's a difficult print, so you might have to adjust your settings here and there.
You'll need to use retraction for the TPU. 230* nozzle and 70* plate.

You should install the foam padded tape on the GPS first, but do not remove the backing to expose the sticky part to the TPU mount. This creates padding and the proper height for fitting the GPS into the mount and snapping it into perfect position. When you push the GPS into the socket, you'll need to feed the wires through the tunnel, then slip one side of the GPS into the mount first and push it in until it slips into the socket. It's a bit of a tight fit but it was designed that way on purpose. It will hold itself in.

It took me 3 days to design this thingi. If you use it, please drop me a like or a make!
Thank you!
=)
-Casey