March 4, 2019
Description
If you would like to support these projects, please visit my website or my Facebook page.
All required frame parts are attached here (two total).
The stock parts for this frame are available here for free.
The ducted base, and speed hole canopy/top are available only on my website along with a pre-configured Simplify 3D factory file to make sure all your supports and setting are right on your first slice.
https://www.3dprintair.com/
https://www.facebook.com/
This frame is currently under development.
There are two major parts to this build, the top and the bottom. There are two different version of the top and bottom parts, and they are all cross compatible, and can be swapped based on your preference for your print. The Top part encapsulates two m3 nuts. Two m3 bolts (preferably GF nylon material) thread through the base to secure the top part. The top is also held in place by 18 fingers that keep the two parts flush at all time.
It is meant to fit 0703 brushless motor from Racerstar using 40mm propellers, a 1s 550mah, a foxeer micro camera, and up to two 20x20 boards stacked on the base part.
There is room left for a stand-alone vtx or rx in the rear of the top part.
https://www.getfpv.com/racerstar-br0703b-15000kv-motor.html
https://www.getfpv.com/foxeer-arrow-micro-pro-600tvl-fpv-camera-black.html
https://www.getfpv.com/xilo-550mah-1s-50c-high-voltage-lipo-battery-jst-ph-2-0.html
License:
Creative Commons - Attribution - Non-Commercial - No Derivatives
3DPrintAir
