March 6, 2019
Description
Kinda long for a wrench that is plastic...so I imported to tinkercad...cut out a 50mm block, rejoined the halves
Made a "shorty...don't need insane torque to tighten an ER11, if the tool was metal I could understand it being so long...for Abom torque ;)
Kudo's to Saur0n for his AWESOME CNC ER11 wrench - upgraded design
For mine...I scaled 101% in X and Y, Z at 100% (for a little tolerance) printed 4 shells, 4 top, 4 bottom, and 40% cubic infill to make sure it has good 3 dimensional strength
-update- Found the open end to be just a tiny bit too tight..even after upscaling...measured and the knotch on the long part is 14mm...make a new one with 14mm space...the enclosed side scaled up 101% fits like a glove
License:
Creative Commons - Attribution
WarHawk8080
