As i needet this to fit on a bigger table i changed the distance between the clips to 6cm (2,3622 inch).
And in addition to that i also modified the stick and knob so that i can light it up a bit.
i used a WS2812b digital LED which lights up green and when a button is pushed it blinkes red.
Also if not used for a while it will go through a rainbow routine.
The wires for the LED run through the stick.
Use a transparrent filament for the knobV2_top (i used 5% infill)
Only thinges needed in addition to the original:
- 3 x M3x30 Bolts
- 3 x M3 Nuts
- 1 x M8x50 Bolt
- 1 x Digital LED
- some wires
- and if you want to diable the LED a switch. Just drilll a hole if you need.
Libraries needed for the code to run: Joystick and FastLED
If you dont need the led use GetShifty-WO-LED.ino
DirAgAlok
