April 16, 2019
Description
I added a hole for a potted plant and a smaller drainage hole down the center.
I printed mine at 197.97% scale for the green version, and 50% scale for the blue one - it was a quick test print. I had my print settings a bit off, and was using old filament, so it didn't print the best. At 197.97% scale it perfectly fits a succulent planter 3.5 inches in diameter (8.89 cm).
The smaller one I printed at .2mm with 10% infill in blue inland pla, and that turned out pretty perfectly with no supports... the larger one I rushed with 5% infill and it got a little messy.
Like an onion, my ogre has very visible layers.
I put ogre ears in mine. Enjoy!
License:
Creative Commons - Attribution
Capnmergn
