Copic Sketch storage 54 Slots

This storage can contain 54 copic sketch

?? a file with a test version is provided to check that the dimensions are correct on your printer - print at least 10mm high)

the space between the lines allows you to grasp the markers without any problem.

the box is not stackable, but the solidworks file is provided so you can edit it as you wish.

A good margin is provided for the insertion of each copic in order to avoid scratching them

Print was done with Grey grossiste3D PLA (195°C) with the slot opening on top of the print.

i suggest to play with variable settings

bottom (1mm upper than slot bottom ) : layer 0.3, infil 25%
middle (few millimeters below top surface) : layer 0.3 infill 0%
top section : layer 0.2, infill 25%

using that variable settings you can save a lot of material :)

perimeters : 2
top : 5 layers
bottom : 4 layers