Classy Trash Can Liner

This is a classy full trash can liner that has a lip on the top so you can use a rubber band around the top to keep the bag in place. I printed it so I can keep my nice stone trash can clean and classy looking. This can also act as a trash can itself. I printed it with a 1mm nozzle in PETG and a 0.5mm layer height and two perimeter walls. This gives it a wall thickness of 2.4mm, so it is pretty darn strong. I printed it with 5 bottom layers for a thickness of 2.5mm and 0 top layers with 0% infill, so it prints it open and hollow.

The height is 230mm and the inside it 166mm in diameter. You can easily scale it in the slicer to meet your needs.

Using the clear filament, it comes out frosted or translucent white looking. This would also be nice as a lampshade, as it should diffuse the light nicely but still let it pass through. I've printed this a few times and noticed that the slower you go with this PETG filament, the more translucent it is. The faster the print speed, the more opaque it is. I use an E3D Volcano hotend with a 40 watt cartridge heater and verified that the temperature stayed a constant 245C. This means that the opaqueness was not due to temperature variance. The two speeds I used were 40mm/sec and 80mm/sec.