This is a little canister cable length adjuster/aligner for lamps
that hangs from the ceiling .
If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
I designed this because i was very tired of having 2 lamps
dangling from the ceiling sitting in line and they was not
equally aligned in the height.
Prior to this i used rubber band to roll the cable in the top
so i could align the lamps somewhat decent .
This is much better looks better and it is very easy to push the cable
into the canister in the top and bottom so you can place
both the canister and the lamps in the same height and
then just tighten the m2 screws so that it locks the cable .
I have approximate 10 cm extra in cable length that is rolled
up into the canister ,i do not think it is wise to have more than
10 cm extra cable length or you could end up not being able
to close the canister .
Note:
Use 4 x m2 - 8mm bolt ,no longer than this ,6mm might work
4 x m2 - hex nut
You do not need to print this with support ,but the holes
where the m2 hex nuts should be ,you might need to scrape
out some loose filament ,but it depends on how good
settings you have on your printer .
8orge
