Hamster-Powered Mecha

Link to the video: https://www.bilibili.com/video/av52876175

In Addition to 3D printed parts, you will need:

Strandbeest Kit x 1
hamster ball (12 cm) x1
bearing (id 5mm od 5mm) x 2
M3 x 8mm bolt x 4
M3 nut x4
16 teeth or 20 teeth timing belt pulley (5mm bore) x 2
60 teeth timing belt pulley x2
320mm timing belt loop x2

In the cover pic, the transmission is only installed on one side. However, you can install it on the both sides (Just print two ball supports with long shaft instead of a long one and a short short). And the bill of materials above is enough for the both side installation.

A drilling hole locator (the one without a shaft) is included to assist you to mark the hole locations for drilling

仓鼠机甲的打印文件。

没有3D打印机的同学把这些文件交给淘宝的3D打印服务就好了。实心打印就好了

下载之前点个收藏点个赞吧。

未经许可不可商用。

额外零件：
Strandbeest (风力仿生兽) 一套

内径5mm 外径10mm 轴承 x 2
直径12cm 仓鼠球 x1 （如果给仓鼠用，建议跟教程里一样买全透明的，保证仓鼠视野）
M3 X 8mm 螺丝 x 4
M3 螺母 x 4
内径5mm （16齿或20齿）同步带轮 x 2
内径8mm (60齿) 同步带轮 x 2
320mm 闭口同步带 x 2