Raspberry PI Mini NAS

Introduction

I want to make a clean looking (no cables in and out the case) small Raspberry PI NAS including 2.5" HDD Mount and internal USB->Sata.

Electrical knownlegde is required to unsolder/cut the Raspberry PI USB Connector and solder a USB->Sata adapter directly to it.

I also used a custom DC-Jack because i would like to plug in Ethernet and Power from one side.

With FAN Edition (w_fan)

I created a slightly bigger Version of the Case foe two Reasons:

• Fit HDDs higher than 10mm
• Fit an 40mm FAN

Case

The Raspberry PI is not easy to fit because of the Audio Jack but when its in it helds itself in position even without Screws.

Instructions

Unsolder the right USB Mount and solder a cheap off the shelf USB->Sata adapter to it.