Rocker Switch Panel XT60 mount

This is a xt60 mount for both male and female xt60s that use a m2 screw (25mm) to hold the xt60s in place. To use you need to hold the xt60 in the mount and drill a small hole thru the xt60 (dont worry terminals dont touch and no worry about shorting out if done correctly/straight), the m2 screw goes from one end to the other and holds the xt60s in place, the arms swing out to hold the 3d print from coming out of the rockerswitch opening. (2) m2 screws are needed for the arms and (2) m2 nuts are needed (1 set/arm). the arms hold well though you still cant rip the xt60 out with no concerns, just wiggle the connector when removing in my experience. I have yet to pull the mount out of my rocker switch hole. No glue is needed at all

I printed in PETG and its held up well in the bed f my truck in 105+ degree heat