Magnetic Light-Ring for Dremel 220 Workstation

Just few days ago, I published another version of the Light-Ring for Dremel 220. In that occasion, I suggested to upgrade by use of magnets. When I came up with the idea, I couldn't resist. So, I did it by myself. :p

With respect to the older version, you'll find following changes:

• Magnets on the back side of the holder outer.stl.
• Additional STL to be printed (magnet holder.stl). It is necessary to properly fix opposite magnets on Dremel Worstation (around the locknut).
• In this case, LEDs are flush with holder outer.stl component. This change was necessary since LEDs can obstruct the tightening of tools into Dremel.
• This is absolutely cooler then previous one :P

As magnets, I used 6 neodymium magnets with sizes 5x10x1mm.
Note: pay attention to magnetic polarity before fixing everything!

Enjoy :)

https://youtu.be/WI6uVrklOHY