June 24, 2019
Description
Canopy for the RunCam Eagle / Swift style FPV cameras. This replaces the top two foam pieces of the model. Add a magnet to assist in securing the canopy. There is a hole allowing the camera power/signal wire to go down into the fuselage.
The cutout for the camera is offset 2.5mm on all sides.
I have included two canopy models for printing flat or angled (60 degree offset angle).
Print the knob separately and glue to bottom.
No supports needed to print. minimal infill required but I would increase the perimeter or shell count for strength.
License:
Creative Commons - Attribution - Non-Commercial
RotorGator
