Gardenhose Male to 1/2 swing pipe

The original connector by did not fit my needs so i remixed it. Using most of the Hose side and my swing pipe coupler.
I have two bronze water statues that I connected several years ago and I had a hard time finding what i needed on amazon or in home depot, but I made it work. Basically by making this connector i was able to remove all of the junk and make a simple connection from a water hose to a garden hose y-valve to 1/2 in id swing hose. which connects to the statues. Works better than what I had before and much cheaper.
I used PETG since this water is chlorinated and the connections may get some sun. I print garden hose end down, and no supports.
I did not try it without, I did go ahead and put rubber washers in to make sure it did not leak on the hose side.