Creality Ender3 and Cr-10 bed level test

Hey there. It's been quite some time since I posted anything new on here but I felt this was a must!
If you have a Creality 3d printer you need to manually level the bed. It took me an entire day to get my bed leveled. I tried other Print tests with no good results so I created one based on the Original Prusa i3. Esentially it is a zig zag print of a single layer with a square at one end.

Print this with PLA. Setting for this are important.
Layer Height .3mm
Print Speed 35 mms
No Build Plate adhesion of any kind is needed. None is preferred.