Summary

The suction cup on my dashcam finally gave away due to excessive heat and use. I decided to print a replacement mount. While there are a lot of mounts out there, none of them fit my car or worked with my mirror.

I took 3 separate prints and re-hashed them into a single model that worked with my car. There are two different mirror clamps. One that is standard and one that is slightly smaller.

I printed this in PETG hoping that it will handle the heat better than PLA. We shall see.

Print Settings

Printer Brand:

Anycubic

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>All-metal Mega</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25%</p></div></p>                                                    <strong>Filament:</strong> Hatchbox PETG                Orange                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I used my Anycubic i3 Mega and PETG filament at 235 degrees and 25% infill. I just used screws I had laying around in the garage. Minimal supports needed. You may get away without using any. </p></div>

Dash Cam Rearview Mirror Mount

Dash Cam Rearview Mirror Mount

Related Models