Raspberry Pi 4 Case (mount for the massive Alu Case)

Newer version here: https://www.thingiverse.com/thing:3835534

When it comes to a Raspberry Pi 4 housing, you either have to have an active cooler or leave place for massive passive heat dissipators.
But with the Raspberry Pi 4 aluminium armor case (Just google that, than you should find something around 10 bucks), wich comes with thermal Pads included, even under massive load, CPU temp will normally range from 50 to 60°, wich is okay (without, it would tell you something around 80° and cut cpu throttle).
It's still possible to use wifi because of the big cut outs.

This thing here is a vertical mount for that housing, with some extra compartment for something you connect with the GPIO - in my case a real time clock. It's meant to point with USB side down. It has a little roof on the upper (SD Card Side), because this mount is for a sailboat, and whenever a drop of water comes inside the wooden cabin, it's not meant to soak the plugs. The roof also can be used to fix video cable or power cable to bend it to the side (see last picture). Even the backside of the Armor-Case is vented by a 2mm Slot. It has six mountholes, but be sure to use flat head screws on the left side.

I printed it with PLA, scaled to 101% Width and 101.5 % along the long side. 4 x M3 screws are needed.